跳到正文
研踪PaperTrail

论文库

检索计算机领域论文,按研究方向、作者或关键词筛选。

部分采集异常
正在读取账号与研究记录…

全站更新概况

+1112新增论文
+875其中 AI 相关
+133已有论文修订
+97新增 AI 导读

arXiv 最近完成扫描:2026-11-20 04:39 · 全站最近入库:2026-11-19 19:09各信源进度 →

统计口径与数据新鲜度

统计 2026-11-19 05:34 — 2026-11-20 05:34(北京时间) · 点击数字查看对应简报;AI 相关包含在新增论文内。

最近完成检查:2026-11-20 04:39最近发现新增版本:2026-11-19 19:09库内论文最新更新时间:2026-11-19 02:59

每分钟刷新已保存的数据。空检查不代表采集异常;新收录可能包含历史论文。AI 导读按新增版本计数。

27,982 已收录论文23,249 AI 相关8,559 有修订112 HF 社区发现

浏览论文库

时间范围跟随排序:版本更新、本站收录或首次发表。最新收录可能包含历史论文。部分信源异常,查看状态 →

找到 1 篇论文 · 按版本更新时间排序上轮扫描起点 2026-11-20 04:38(北京时间)
版本更新 · v2arXiv:2605.10093

RFAmpDesigner: A Two-Level LLM-guided Optimization Framework for Automated Differential CMOS RF Amplifier Sizing

Hang Lu, Guochang Li, Qianyu Chen, Huiyan Gao, Shaogang Wang, Xuanyu He, Yiwei Liu, Gaopeng Chen 等 12 位作者

原文摘要

Automated RF amplifier sizing is challenging because the design process is inherently hierarchical, the parameter space is high-dimensional and strongly coupled, and high-fidelity circuit simulation is expensive. Conventional optimization and reinforcement learning methods typically require many iterations and make limited use of RF domain knowledge, making them costly under tight simulation budgets. Large language models (LLMs) provide broad prior knowledge and reasoning capabilities, but are unreliable for direct numerical optimization. This paper presents RFAmpDesigner, a two-level optimization framework for automated schematic-level sizing of differential CMOS RF amplifiers. At the outer level, the circuit-parameter space is abstracted into a resource-allocation space, where LLMs make high-level allocation decisions and adjust them according to feedback from the inner level. At the inner level, RF design knowledge is used to decompose the flat sizing problem into a sequence of low-dimensional subproblems. Conventional optimizers then solve these subproblems to find circuit implementations consistent with the assigned resources. This structure allows numerical optimizers to focus on low-dimensional searches in the circuit-parameter space, while the LLM reasons and acts over a physically meaningful design space using simulation feedback. The main evaluation covers low-noise amplifier (LNA), driver amplifier (DA), and power amplifier (PA) designs within the target differential CMOS RF amplifier family. Experimental results show that it achieves a higher success rate under a limited simulation budget in both easy and hard regimes.

cs.AR