Sparse inertial motion capture typically assumes that each sensor's anatomical identity and mounting orientation are known. We present MOSAIC (Motion-based Sensor Assignment and Inertial Calibration), a framework that recovers this setup from ordinary motion without a calibration pose. Our central insight is that body pose changes continuously while the sensor setup persists, allowing movements that are individually ambiguous to provide complementary evidence over time. A setup network processes unordered sensor streams with temporal and cross-sensor attention, then accumulates assignment and rotation evidence into a session-level estimate. The recovered setup canonicalizes measurements for frozen pretrained pose estimators, separating sensor configuration from motion reconstruction. For sensors worn at prescribed body sites, evaluation on real inertial recordings with randomized setups shows near-calibrated pose accuracy for bounded offsets and substantial benefits from accumulation under arbitrary orientations. Transfer across pose networks supports setup recovery as a reusable interface between interchangeable sensors and pretrained pose models.
Human demonstrations provide a natural and scalable source of data for learning dexterous manipulation policies. However, existing retargeting methods primarily transfer human kinematics, while the tactile information underlying physical interaction is rarely preserved across embodiments. To address this limitation, we present a hierarchical three-stage framework for kinematic-tactile aligned dexterous retargeting. We use object-centric contact wrench space as a physical representation for tactile alignment between human and robot hands. The framework first aligns hand kinematics and contact geometry, and then constructs a human wrench support profile from tactile forces and contact geometry. Robot fingertip force targets are subsequently optimized to cover the human wrench support and converted into joint position corrections, yielding directly replayable robot hand trajectories. We evaluate the framework in simulation and real robot experiments across three pouring conditions. In the real robot experiments, our method achieves a 96.7\% replay success rate and higher wrench transfer fidelity than representative retargeting baselines. The framework enables physically grounded transfer of kinematic and tactile information from human demonstrations to robot hands, providing a path toward scalable learning of contact-rich dexterous manipulation.