跳到正文
研踪PaperTrail

论文库

检索计算机领域论文,按研究方向、作者或关键词筛选。

部分采集异常
正在读取账号与研究记录…

全站更新概况

+729新增论文
+575其中 AI 相关
+82已有论文修订
+95新增 AI 导读

arXiv 最近完成扫描:2026-11-21 12:19 · 全站最近入库:2026-11-21 12:19各信源进度 →

统计口径与数据新鲜度

统计 2026-11-20 16:05 — 2026-11-21 16:05(北京时间) · 点击数字查看对应简报;AI 相关包含在新增论文内。

最近完成检查:2026-11-21 12:19最近发现新增版本:2026-11-21 12:19库内论文最新更新时间:2026-11-20 02:59

每分钟刷新已保存的数据。空检查不代表采集异常;新收录可能包含历史论文。AI 导读按新增版本计数。

29,158 已收录论文24,181 AI 相关8,992 有修订112 HF 社区发现

浏览论文库

时间范围跟随排序:版本更新、本站收录或首次发表。最新收录可能包含历史论文。部分信源异常,查看状态 →

找到 1 篇论文 · 按版本更新时间排序上轮扫描起点 2026-11-21 12:17(北京时间)
新论文 · v1arXiv:2611.25921

A Lightweight Hybrid Approach for Milling Force Reconstruction from Internal Machine Signals

Eric Hirsch, Christian Friedrich

原文摘要

Data-driven monitoring based on milling force can enable advanced manufacturing services including process optimization and condition monitoring. However, industrial implementation is often hindered by costly and intrusive hardware and large training data requirements. This paper therefore presents a hybrid approach using machine-internal signals and machining metadata to enable force-based monitoring on brownfield machines without additional sensors. Commonly available machine signals have relatively low sampling rates and cannot directly represent high-frequency milling-force variations, especially at higher spindle speeds. Instead of learning the complete force signal, which would increase model complexity, data requirements, and overfitting risk, a supervised machine-learning model predicts only the average milling force from selected machine-signal features and machining parameters. This low-frequency estimation parameterizes a static milling force model that reconstructs the force behavior over one spindle revolution. Although the static model does not reproduce all dynamic effects, it captures the force distribution, load levels, and angular regions of highest tool engagement. The approach is evaluated on one milling machine across varying process parameters, engagement conditions, cutting tools, and two workpiece materials. Dynamometer measurements are required only for development and validation. Ridge regression achieves an $R^2$ of $0.984$ and $0.991$ for average-force prediction on the test data ($\bar{F}_x$ and $\bar{F}_y$). The reconstructed force behavior over one spindle revolution achieves an $R^2$ of $0.962$ and $0.982$ ($F_x$ and $F_y$) compared with the reconstruction based on measured force features. The method provides a cost and computationally efficient basis for process monitoring, tool condition assessment, and process optimization on existing machines.

cs.LG