跳到正文
研踪PaperTrail

论文库

检索计算机领域论文,按研究方向、作者或关键词筛选。

部分采集异常
正在读取账号与研究记录…

全站更新概况

+549新增论文
+443其中 AI 相关
+62已有论文修订
+95新增 AI 导读

arXiv 最近完成扫描:2026-11-21 12:19 · 全站最近入库:2026-11-21 12:19各信源进度 →

统计口径与数据新鲜度

统计 2026-11-20 18:39 — 2026-11-21 18:39(北京时间) · 点击数字查看对应简报;AI 相关包含在新增论文内。

最近完成检查:2026-11-21 12:19最近发现新增版本:2026-11-21 12:19库内论文最新更新时间:2026-11-20 02:59

每分钟刷新已保存的数据。空检查不代表采集异常;新收录可能包含历史论文。AI 导读按新增版本计数。

29,158 已收录论文24,181 AI 相关8,992 有修订112 HF 社区发现

浏览论文库

时间范围跟随排序:版本更新、本站收录或首次发表。最新收录可能包含历史论文。部分信源异常,查看状态 →

找到 2 篇论文 · 按版本更新时间排序上轮扫描起点 2026-11-21 12:17(北京时间)
新论文 · v1arXiv:2611.18186

NPU-Accelerated GNSS Signal Acquisition

Taro Suzuki

原文摘要

On small single-board computers (SBCs), GNSS signal acquisition is a major CPU load. This paper proposes using the neural processing unit (NPU) of an SBC not for machine learning but as an accelerator for the parallel code search in GNSS signal acquisition. The discrete Fourier transform (DFT) used in acquisition is decomposed by the four-step DFT into matrix products of small DFTs and expressed by $1\times1$ convolutions, element-wise products, and transposes, which NPUs execute efficiently. Furthermore, we propose a method that divides the DFT, the non-coherent integration, and the peak detection between the CPU and the NPU according to the configuration of the NPU (an NPU with its own memory connected via PCIe, or an NPU sharing memory with the CPU). The proposed method is implemented in the open-source software GNSS receiver Pocket SDR and evaluated on a Raspberry Pi 5 combined with the external AX8850 NPU and on the NPU built into the SoC (RK3588) of the ROCK 5C, a small SBC of comparable size. Compared with acquisition by an optimized CPU implementation, the acquisition of short codes on the Raspberry Pi 5 with the AX8850 is 3.0-3.8 times faster. In the evaluation of the whole receiver, the number of tracking channels that reach their first lock within 30 s with the NPU is 1.5 times that with the CPU, and the time until 90% of the channels are locked is reduced from 66 s to 26 s. Furthermore, because the CPU load of acquisition is reduced, the number of tracking channels that can be processed in real time increases from about 175 to about 230. These results show that using the NPU on SBCs with limited CPU resources is effective for achieving both GNSS signal acquisition and tracking. The implementation is publicly available as open source under the name PocketSDR-NPU.

cs.RO

版本更新 · v2arXiv:2606.21387

Long-Distance Real-World Navigation of the Legged-Wheeled Robot Go2-W Using Deep Reinforcement Learning

Takaaki Matsuzawa, Kiyoshi Irie, Tomoaki Yoshida, Taro Suzuki, Yoshitaka Hara, Masahiro Tomono

原文摘要

Legged-wheeled robots have been extensively studied for their potential to combine the efficient flat-ground mobility of wheels with the rough-terrain adaptability of legs. However, their application to long-distance autonomous navigation in real environments remains limited. This paper reports our efforts to build a deep reinforcement learning-based locomotion controller and an autonomous navigation system for the commercially available Go2-W legged-wheeled robot. The study focuses on the integrated system and the practical challenges associated with its sustained operation over long distances in real-world environments. For locomotion control, we extended our proprioception-only policy, previously developed for quadruped robots, to Go2-W, a 16-degree-of-freedom legged-wheeled robot. We additionally found that wheeled locomotion concentrates the load on the hip joints, resulting in heat concentration that hinders sustained travel. To address this issue, we developed a policy with periodic foot-lifting motion that distributes the joint loads and mitigates heat concentration. We evaluated the integrated system at the Tsukuba Challenge 2025. The robot autonomously traversed an approximately \SI{2.8}{\kilo\meter} route that included sidewalks, a park, and stairs without stopping owing to overheating.

cs.RO